Welcome to the official website of BORUNTE
Borunte Robot Co., Ltd+0086-400-870-8989
Four-axis servo Manipulator

BRTNN15WSS4P/F

Four-axis servo Manipulator

  • Simple Operation
  • Quick response
  • Safe And Efficient

Product Introduction

BRTNN15WSS4P/F series applies to all types of horizontal injection machine ranges of 470T-800T for take-out products. The vertical arm is the telescopic type with the product arm. Four-axis AC servo drive, with a C-servo axis on the wrist, the rotation angle of the C-axis:90 ° . Save time than similar models, accurate positioning, and short forming cycle. After installing the manipulator, the productivity will be increased by 10-30% and will reduce the defective rate of products, ensure the safety of operators, reduce manpower and accurately control the output to reduce waste. Four-axis driver and controller integrated system: fewer signal lines, long-distance communication, good expansion performance, strong anti-interference ability, high accuracy of repeated positioning, can simultaneously control multiple axes, simple equipment maintenance, and low failure rate.

  • Accurate positioning

    Accurate positioning

  • Fast

    Fast

  • Long service life

    Long service life

  • Low failure rate

    Low failure rate

  • Reduce labor

    Reduce labor

  • Telecomm unication

    Telecomm unication

Basic Parameters

Power Source (kVA) Recommended I.M.M (ton) Traverse Driven Model of EOAT
2.59 470T-800T AC Servo motor two suctions two fixtures
Traverse Stroke (mm) Crosswise Stroke (mm) Vertical Stroke (mm) Max.loading (kg)
2200 900 1500 15
Dry Take Out Time (sec) Dry Cycle Time (sec) Air Consumption (NI/cycle) Weight (kg)
2.74 9.03 3.2 680

Model representation: W:Telescopic type. S:Product arm. S4：Four-axis driven by AC Servo Motor(Traverse-axis、C-axis、Vertical-axis+Crosswise-axis)

The above-mentioned cycle time are the results of our company's internal test standard. In the actual application process of the machine, they will vary according to the actual operation.

trajectory chart

ABCDEFG
1742328415005622200/256
HIJKLMN
//1398.5/341390900

No further notice if the specification and appearance are changed due to improvement and other reasons. Thank you for your understanding.

Precautions for Storage and Handling Caution:

Do not store or place the machine in the following environment, otherwise it may cause fire, electric shock or machine damage.

1. Places exposed to direct sunlight, places where the ambient temperature exceeds the storage temperature conditions, places where the relative humidity exceeds the storage humidity, or places with large temperature differences or condensation.

2. Places close to corrosive gas or flammable gas, places with a lot of dust, salt and metal dust, places where water, oil and medicine drip, and places where vibration or shock can be transmitted to the subject. Please do not grab the cable for transportation, otherwise it will cause damage or failure of the machine.

3. Do not stack too much products on the machine, otherwise it may case machine damage or failure.

Product Recommendation

Purchase Consultation