Two-Axis Robot
BRTYZGT02S2B type robot is a two-axis robot developed by BORUNTE. It adopts a new drive control integrated control system, with fewer signal lines and simple maintenance. It is equipped with a handy mobile hand-held operating teaching pendant; the parameters and function settings are clear, and the operation is simple and fast. The whole structure is driven by a servo motor and RV reducer, which makes the operation more stable, accurate, and efficient.
Accurate positioning
Fast
Long service life
Low failure rate
Reduce labor
Telecomm unication
Applicable to die casting machine | 160T-400T |
Msnipulator Motor Drive(kW) | 1kW |
Tableapoon Motor Drive(kW) | 0.75kW |
Arm reduction ratio | RV40E 1:153 |
Ladle reduction ratio | RV20E 1:121 |
Max.loading(kg) | 4.5 |
Recommended tableapoon type | 0.8kg-4.5kg |
Tableapoon Max(mm) | 350 |
Recommended height for smelter(mm) | ≤1100mm |
Recommended height for smelter arm | ≤450mm |
Cycle Time | 6.23 (within 4s, the arm standby position starts to descend until the soup is injected) |
Main control power | AC Single phase AC220V/50Hz |
Power Source(kVA) | 1.67kVA |
Dimension | length, width and height(1140*680*1490mm) |
Weight(kg) | 220 |
No further notice if the specification and appearance are changed due to improvement and other reasons. Thank you for your understanding.
Precautions for Storage and Handling Caution:
Do not store or place the machine in the following environment, otherwise it may cause fire, electric shock or machine damage.
1. Places exposed to direct sunlight, places where the ambient temperature exceeds the storage temperature conditions, places where the relative humidity exceeds the storage humidity, or places with large temperature differences or condensation.
2. Places close to corrosive gas or flammable gas, places with a lot of dust, salt and metal dust, places where water, oil and medicine drip, and places where vibration or shock can be transmitted to the subject. Please do not grab the cable for transportation, otherwise it will cause damage or failure of the machine.
3. Do not stack too much products on the machine, otherwise it may case machine damage or failure.